Eagle Hot Air Tarp Welder

TOOWE2840

Specifications

Specifications

Product NameEagle Hot Air Tarp Welder
Part NumberTOOWE2840
CatalogueThis Product is on Page 137 of the J.Ennis Supply Catalogue 6th Edition., This Product is on Page 378 of the J. Ennis Supply Catalogue 5th Edition, This Product is on Page 320 of the J. Ennis Supply Catalogue 4th Edition
CautionsIncorrect tool use can cause a fire. Be sure to lay the tool on a fireproof surface when not in use. To avoid burns do not touch the heating element holder or nozzle while the tool is in use. The tool should be protected from damp or wet conditions. To ensure tool safety the carbon brushes should be checked and/or replaced after about 1600 hours of use.
CollectionSupply Catalogue 5th Ed
Dimensions12.6" x 3.7"
ElectricalWattage: 1600W @120 VAC. 120VAC, 50 Hz
FeaturesFeatures include a recessed temperature control knob, a booted power switch and screened air inlet to protect the Eagle against damage. Air flow is adjustable up to 15 CFM. Built in over temperature protection, protects the heating elements and electronics from thermal damage., Compact, light-weight unit fits comfortably in your hand and is available with a variety of nozzle tips to weld virtually any type of material. Double-insulated and ISO color coded for added electrical safety., Handheld hot air welder unit. This unit will lap weld soft thermoplastics without any additional materials other than the use of a silicone roller to provide the necessary pressure to weld. Particularly suited to welding of tarpaulins and single ply roofing material. The air temperature out of this unit infinitely adjustable from the ambient up to 625 degrees Celsius., The element is a quick change type, with no tools required. Runs on standard house current, although a 220 Volt model is available on spec
InstructionsMake sure the voltage is the same as shown on the name plate. Turn the unit on using the rotary switch, set the unit to the desired heat output. It takes approximately 4 minutes for the tool to attain its full operating temperature. When Finished, cool the heating element down by turning the rotary switch to position 1. This action will extend the life of the heating element. After the unit has cooled down, turn the tool off.
UsesUsed for heat welding of PVC's and other materials.
Warranty6 month warranty
To top